| Description | In the Linux kernel, the following vulnerability has been resolved: tpm: Make the TPM character devices non-seekable The TPM character devices expose a sequential command/response interface, but their open handlers leave FMODE_PREAD and FMODE_PWRITE enabled. After a command leaves a response pending, pread(fd, buf, 16, 0x1400) passes 0x1400 as *off to tpm_common_read(). The transfer length is bounded by response_length, but the offset is used unchecked when forming data_buffer + *off. A sufficiently large offset therefore causes an out-of-bounds heap read through copy_to_user() and, if the copy succeeds, an out-of-bounds zero-write through the following memset(). Positional I/O does not provide coherent semantics for this interface. An arbitrary pread offset cannot represent how much of a response has been consumed sequentially. The write callback always stores a command at the start of data_buffer, while pwrite() does not update file->f_pos and can leave the sequential read cursor stale. Call nonseekable_open() from both open handlers. This removes FMODE_PREAD and FMODE_PWRITE, causing positional reads and writes to fail with -ESPIPE before reaching the TPM callbacks, and explicitly marks the files non-seekable. Normal read() and write() continue to use the existing sequential f_pos cursor, leaving the response state machine unchanged. Tested on Linux 6.12 with KASAN and a swtpm TPM2 device: - sequential partial reads returned the complete response - pread() and preadv() with offset 0x1400 returned -ESPIPE - pwrite() and pwritev() with offset zero returned -ESPIPE - the pending response remained intact after the rejected operations - a subsequent normal command/response cycle completed normally - no KASAN report was produced. |